Screws in those pegs ensured the board was held down tight and could not slip off. The Dragon board was just wide enough to sit on the edge of these pegs. The enclosure had board mounting pegs that were made for the Dragon board. The translucent grey allowed for great visibility of the status LED’s of the Dragon. The Serpac H-65 in translucent grey was purchased from DigiKey. It proved to be a perfect fit for “my” Dragon. After some searching I came across the Serpac H-65 enclosure. It arrived in a very stylish red little box, but no cables, enclosure or anything else for that matter. It promised to not only provide ISP (In-circuit Serial Programming), but also JTAG, debugWire and high voltage programming for AVR device. The Dragon was quite inexpensive and readily available at DigiKey. I obtained this little beast because my old AVRISP serial programmer was useless due to lack of serial hardware on my PC. The Atmel AVR Dragon is a new programmer for Atmel AVR 8-bit Microcontrollers.
0 Comments
Leave a Reply. |